trailer on the pad to stay as long as I need. You have to limit your usage to be below the 15 or 20 Amp limit for the circuit you are hooked. Plugging In The Trailer, once you have installed the three prong adapter on the power cord from the travel trailer it is time to plug. Please note, electrical panels are dangerous to work in, never touch any of the main bus lugs in the panel, they can kill! Should be on its own connection screw hole within the neutral bus. X Y are interchangeable, red and black wires are hot (live) wires, one wire on the X, and the other on the. If the circuit breaker goes off again, double check to make sure that all electrical appliances in the Travel Trailer are turned off.
Appliance Aid 3 wire dryer power systems are for use with existing ungrounded dryer receptacles mainly in older homes whose wiring in years gone by was not grounded. The ground bus is a terminal block with many small holes where the bare ground (or green wire) can be connected and tightened into place with a screw.
Dryer Cord - 4 wire hookup at Dryer. The red and black wires from dryer cable connect to the dual 30 amp breaker, one to each of the dual breakers. There must also be a green jumper wire installed between the center connection on that connecting block in the dryer and the metal frame of the dryer on a green screw. In the sample picture above the ground strap in folded over and is connected to the center connector but NO connection from it or jump to ground. In the diagram above the bare ground is indicated by a green line. The breaker used must be a dual (double) 30 amp 220v breaker. The white connects to the center connecting lug and the bare connects to the green connecting lug or screw. A ppliance Aid, a 4 wire dryer cord contains a black, red, white and green wire. Either one of the adapters listed below will work.